Replacement Remote(B) for Existing Gen-5 Users
Instruction Manual
Before using this product, please read this instruction manual carefully. After reading, please keep it properly for future reference.
- LED Light Bar
- Fan Power Off
- Fan Rotation Direction Clockwise / Counterclockwise
- Fan Speed Increase / Power On
- Fan Speed Decrease / Power On
- Light On/Off
- LED Dimmer Indicator Light
- LED Dimmer
- LED Color Select Indicator Light
- LED Color Select
Function Description
- LED Light Bar: Displays the fan speed level according to the command. The levels range from 1 to 6, displayed from left to right
- Fan Power Off: Turns off the fan
- Fan Rotation Direction Clockwise / Counterclockwise: Toggles the fan’s rotational direction
- Fan Speed Increase: Increases the fan speed or Power On the fan when this button is pressed.
- Fan Speed Decrease: Decreases the fan speed or Power On the fan when this button is pressed
- Light On / Off: Turns the light on or off. When the light is on, pressing and holding this button will activate the “LED Off Delay” function
- OLED Dimmer Indicator Light: Lights up when the “LED Dimmer” button is pressed
- LED Dimmer: Adjusts the LED brightness when pressed; the signal can be sent continuously for up to 1 minute
- LED Color Select Indicator Light: Lights up when the “LED Color Select” button is pressed
- LED Color Select: Adjusts the LED color when pressed; total of 4 colors
Pairing Method
- Power “Off” the fan. Not just the remote, Switch “off” the power supply to the fan via a Switch or Circuit Breaker.
- If the Fan was in use. Wait for the fan’s rotation to stop.
- Wait for 60 seconds & Switch the power supply “On”
- When the fan is powered on, you will hear a “beep” sound.
- Remote pairing: Press and hold the “2” key within 30 seconds until you hear the “beep” sound, indicating the pairing is complete.
Notices
- When the remote is unable to control the receiver, check if the battery is in good contact, oriented properly or whether it is drained or not.
- When the remote is unable to control the receiver, please check if other remote control products may be causing interference with each other resulting in poor receiving effect. Removing such articles will normalize the remote control function. (The infrared remote controller is not included).
- Please use this product under applicable voltage. Too low voltage will lead to failure of the remote controller.
- Please remove the batteries if you will not use this product for long periods of time.
- The product can be paired with up to 2 remote units simultaneously.
- Transmission distance: approximately 7 meters.
- Battery requirement: :CR2032 3V Battery x 1
- A 15-second interval is enforced by the remote to stop sending signals between repeatedly pressing OFF and+/- key. However, NO time restriction on repeatedly pressing + / – key.
Warning
- INGESTION HAZARD: This product contains a button cell or coin battery.
- DEATH or serious injury can occur if ingested.
- A swallowed button cell or coin battery can cause Internal Chemical Burns in as little 2 hours.
- KEEP new and used batteries OUT OF REACH OF CHILDREN.
- Seek immediate medical attention if a battery is suspected to be swallowed or inserted inside any part of the body.
Warning
- The coin cell batteries are non-rechargeable batteries are not to be recharged. Do not force discharge, recharge, disassemble, heat above 85°C (185°F) or incinerate. Doing so may result in injury due to venting, leakage or explosion resulting in chemical bums.
- This product contains non-replaceable batteries. Only a qualified technician is to remove or replace the batteries. The coin cell batteries are not replaceable by the customer.
- Chemical Burn Hazard. Remove and immediately recycle or dispose of used batteries according to local regulations and keep away from children. Do NOT dispose of batteries in household trash or incinerate. Even used batteries may cause severe injury or death. If swallowed, batteries can cause serious injury or death in as little as 2 hours. Call a local poison control center for treatment information or seek immediate medical attention if swallowed or placed inside any part of the body
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected
- Consult the dealer or an experienced radio/TV technician for help
Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user authority to operate the equipment. This Transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
